Microe PurePrecision Uživatelský manuál stáhnout pdf (Strana 8)

Page 8

Cutting the PurePrecision

™

Tape Scale

1.

Uncoil the tape scale and cut it to the

required length using shears.

Note: check the interface drawing to make

sure the scale is cut to the right length.

Securely hold the tape scale close

to the shear (at an approximate

distance of 40mm [1½ inches])

near the point of cutting.

Orient the tape scale

perpendicular to the shear.

Cut the tape scale in a smooth,

continuous motion.

Shear held perpendicular to

the tape scale (NOT INCLINED)

Hand approximately at a

distance of 40mm-50mm

(1 1/2 inches to 2 inches)

from the cutting point

Shear held inclined,

not perpendicular,

to the tape scale

NOTE:

When working with any encoder

scale, it is important to use either

finger Cots or talc-free gloves

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 32 33

Komentáře k této Příručce

Žádné komentáře