Microe PurePrecision Uživatelský manuál stáhnout pdf (Strana 10)

Page 10

Tape Scale, OPS Side/Top Mount Configurations

Installation By Hand

Place the PurePrecision

™

Tape Scale against the mounting surface “D” reference edge.

Place the 25mm (1 inch) exposed adhesive end of the tape scale against the mounting surface “D” reference

edge as shown and press firmly on the end.

NOTE:

Adhesive exposed by removing the adhesive bottom liner can touch the mounting

surface only once.

Flip the tape over with the 25mm (1 inch) exposed adhesive surface facing down. Be sure not to touch or

contaminate the exposed adhesive surface. Be sure the orientation arrows on the blue protective film point to

the “D” reference edge.

“D” reference edge as shown in the

OPS interface drawing.

Tape scale orientation arrows.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 32 33

Žádné komentáře

Microe PurePrecision Uživatelský manuál Strana 10